07.21 www.demos‑trade.com 10 max. 20°! !!! 15 15 min. 7 h = H - 12 H 12 12 135 135 60 60 R12 R12 49 49 12 12 10 max. 20°! !!! 135 135 60 60 R12 R12 49 49 12 12 284545 284546 284551 284547 1,5 284549 2 284550 3 FITTINGS FOR SLIDING AND FOLDING DOORS sliding inset wardrobe doors dimensional diagram min. 18 mm ball bearings load 40 kg • elegant solution for inset doors • guide milled into the cabinet body, min. thickness 18 mm • quiet running, high-quality bearings for long life service • soft closing hidden in guide for silent closing of the door • simple regulation, safety latch for easier door installation • the set includes running components in the appropriate quantity, guide end pieces, fasteners and hex key • minimum door width is 600 mm • for centre soft closer mounting, the middle door must be in the rear or the gap between the doors must be enlarged to allow other doors to move • centre soft closer should be mounted to the cabinet body, guiding pin on door bottom guide n Mounting information: 1. Before inserting the guide into the cabinet body, insert soft closers and end pieces to the rail. Please mind the correct orientation of the soft closer – arrows must point to the cabinet body centre. 2. Draw soft closers in the working position (according to the arrow – towards the cabinet body centre). 3. Before installing the door, push top running components in installation position and secure them with a safety latch. 4. Insert the door into the bottom rail, then direct the top running component to the top rail and release the safety latch. 5. Warning – door deflection during installation must not exceed 20°, otherwise the guide or even the cabinet body may suffer damage! 6. Regulate the door position, then secure against unhooking by tightening the top running component. 7. Align and secure the position of soft closing to close the door to the cabinet body side properly. StrongLine LINIO Centre soft closer code description set for 2 doors, 4 × soft closer set for 3 doors, 4 × soft closer code description for a 3-doors set • surface treatment – anodised silver Top/bottom guide code length (m) hole for top running component hole for the bottom running component use of the end pieces of the guide profile correct orientation of the soft closer in the guide profile doors deployment and adjustment
RkJQdWJsaXNoZXIy MzEyMDA=